ISO_IEC_29341-30-1_2017-Character_PDF_documenten.pdf

Information technology UPnP Device Architecture Part 30-1:IoT management and control device control protocol IoT management and control architecture overviewTechnologies de linformation Architecture de dispositif UPnP Partie 30-1:Protocole de contrle de dispositif de gestion et de contrle de lInternet des objets Aperu gnral de larchitecture de gestion et de contrle de lInternet des objetsINTERNATIONAL STANDARDISO/IEC29341-30-1Reference numberISO/IEC 29341-30-1:2017(E)First edition2017-06 ISO/IEC 2017 ii ISO/IEC 2017 All rights reservedCOPYRIGHT PROTECTED DOCUMENT ISO/IEC 2017,Published in SwitzerlandAll rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized otherwise in any form or by any means,electronic or mechanical,including photocopying,or posting on the internet or an intranet,without prior written permission.Permission can be requested from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright officeCh.de Blandonnet 8 CP 401CH-1214 Vernier,Geneva,SwitzerlandTel.+41 22 749 01 11Fax+41 22 749 09 47copyrightiso.orgwww.iso.orgISO/IEC 29341-30-1:2017(E)ISO/IEC 29341-30-1:2017(E)ISO/IEC 2017 All rights reserved iii CONTENTS 1Scope.11.1Introduction.11.2Goals.11.3Non-Goals.11.4IoTManagementAndControl and DataStore Specification Map.22Normative references.33Terms,definitions and abbreviations.43.1IoTManagementAndControl terms and definitions.43.2DataStore terms and definitions.53.3Configuration Management terms and definitions.63.4Device Protection terms and definitions.74Architectural Overview.84.1UPnP IoTManagementAndControl Device.84.1.1Sensor Data Model.94.1.2Sensor Collections.94.1.3Sensor Control.94.1.4Sensors DataItem(s).94.1.5Sensor DataItem Description Document.104.1.6Sensors DataRecord(s).104.1.7Sensors Data Transport.104.1.8Sensors Groups.104.1.9Sensor Protection Model.104.2UPnP DataStore Service.124.2.1DataTable(s).134.2.2DataTable DataRecord(s).134.2.3DataTable Dictionary.134.2.4DataItem types.134.2.5DataTable Operations.144.2.6DataStore Protection Model.144.3DataItem Semantics.154.3.1DataItem Name.154.3.2DataItem Prefix.164.3.3DataItem Type.164.3.4DataItem Encoding.174.3.5DataItem Description Document.174.4DataItem Description XML Document.184.4.1Introduction.184.4.2DataItem Categories.184.4.3DataItem Description Document Elements.184.5DataItem Description Units of Measurement.264.5.1SI Prefixes.264.5.2SI Base Units.264.5.3SI Derived Units.264.5.4Non-SI in common use.274.5.5British units in common use.27ISO/IEC 29341-30-1:2017(E)iv ISO/IEC 2017 All rights reserved 4.5.6Coordinates.274.5.7Duration.284.5.8Encoding.284.6Theory of Operation(informative).294.6.1IoTManagementAndControl Device.294.6.2Configuring the DataStore service.36Annex A Sample Device Illustration(informative).44 Figure 1 IoTManagementAndControl Architectural Components.8Figure 2 IoTManagementAndControl Device services.9Figure 3 DataStore service.12Figure 4 DataStore service-DataTable Components.13Figure A.1 Sample Device.44 Table 1 Sensor Permissions.10Table 2 access=attribute allowed values.20Table 3 treatment=attribute allowed values(measurement).20Table 4 accumulation=attribute allowed values(measurement).21Table 6 relationtype=attribute(alarm).22Table 7 limittype=attribute(limit).23Table 8 relationtype=attribute allowed values(limit).23Table 9 relationtype=attribute allowed values(setting).24Table 10 units=attribute allowed values(interval).24Table 11 relationtype=attribute allowed values(interval).25 ISO/IEC 29341-30-1:2017(E)ISO/IEC 2017 All rights reserved v Foreword ISO(the International Organization for Standardization)and IEC(the InternationalElectrotechnical Commission)form the specialized system for worldwide standardization.NationalbodiesthataremembersofISOorIECparticipateinthedevelopmentofInternationalStandardsthroughtechnicalcommitteesestablishedbytherespectiveorganizationtodealwithparticularfieldsoftechnicalactivity.ISOandIECtechnicalcommitteescollaborateinfieldsofmutual interest.Other international organizations,governmental and nongovernmental,inliaisonwithISOandIEC,alsotakepartinthework.Inthefieldofinformationtechnology,ISOandIEChaveestablishedajointtechnicalcommittee,ISO/IECJTC1.Theproceduresusedtodevelopthisdocumentandthoseintendedforitsfurthermaintenanceare described in the ISO/IEC Directives,Part 1.In particular the different approval criterianeeded for the different types of document should be noted.This document was drafted inaccordancewiththeeditorialrulesoftheISO/IECDirectives,Part2(seewww.iso.org/directives).Attentionisdrawntothepossibilitythatsomeoftheelementsofthisdocumentmaybethesubjectofpatentrights.ISOandIECshallnotbeheldresponsibleforidentifyinganyorallsuchpatentrights.Detailsofanypatentrightsidentifiedduringthedevelopmentofthedocumentwillbe in the Introduction and/or on the ISO list of patent declarations received(seewww.iso.org/patents).Anytradenameusedinthisdocumentisinformationgivenfortheconvenienceofus