ISO_IEC_25437_2012.pdf

Reference numberISO/IEC 25437:2012(E)ISO/IEC 2012 INTERNATIONAL STANDARD ISO/IEC25437Third edition2012-11-15Information technology Telecommunications and information exchange between systems WS-Session Web services for application session services Technologies de linformation Tlcommunications et change dinformation entre systmes Session WS Services web pour services de session dapplication ISO/IEC 25437:2012(E)COPYRIGHT PROTECTED DOCUMENT ISO/IEC 2012 All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2012 All rights reserved ISO/IEC 25437:2012(E)ISO/IEC 2012 All rights reserved iii Contents Page Foreword.vIntroduction.vi1 Scope.12 Conformance.13 Normative references.14 Terms,definitions and namespaces.24.1 Terms and definitions.24.2 Prefixes and namespaces.25 Abstract WSDL Definitions.35.1 Provider WSDL.35.2 Notification WSDL.46 SOAP Binding.46.1 SOAP Binding for Provider WSDL.56.2 SOAP Binding for Notification WSDL.56.3 SOAP Binding of sessionID.56.4 SOAP Fault Messages.67 Event Subscription and Notification.7Annex A(normative)Event Subscription Using WS-Eventing.8A.1 General.8A.2 Subscription Fault.8Annex B(normative)Subscription Using WS-BaseNotification Option.9B.1 General.9B.2 Subscription Fault.9Annex C(normative)Asynchronous Response to Subscription Request Option.10Annex D(informative)Example WS-Session WSDL binding with SOAP/HTTP.11D.1 Service Provider WSDL with SOAP/HTTP Binding.11D.2 Notification WSDL with SOAP/HTTP Binding.12Annex E(informative)SOAP XML Templates for ISO/IEC 22534(ECMA-354)Messages.13E.1 StartApplicationSession request message template.13E.1.1 StartApplicationSession Positive response message template.13E.1.2 StartApplicationSession negative response message template.13E.2 StopApplicationSession request message template.14E.2.1 StopApplicationSession positive response message template.14E.2.2 StopApplicationSession negative response message template.14E.3 ResetApplicationSessionTimer request message template.14E.3.1 ResetApplicationSessionTimer positive response message template.15E.3.2 Reset Application Session Timer negative response message template.15E.4 ApplicationSessionTerminated.15E.4.1 Template of ApplicationSessionTerminated event notification for unwrapped event sink which applies to both WS-Eventing and WS-BaseNotification options.15E.4.2 Template of ApplicationSessionTerminated event notification to wrapped event sink of WS-Eventing.16E.4.3 Template of ApplicationSessionTerminated event notification to wrapped event sink of WS-BaseNotification.16ISO/IEC 25437:2012(E)iv ISO/IEC 2012 All rights reserved Annex F(informative)WS-Eventing SOAP XML Message Templates.17F.1 ApplicationSessionTerminated Event Subscription SOAP message template.17F.2 Template of positive response to the event subscription.17F.3 Template of negative response(fault)to event subscription.18F.4 Template of Unsubscribe message.18F.5 Template of positive response to Unsubscribe message.18Annex G(informative)WS-BaseNotification SOAP XML Message Templates.19G.1 ApplicationSessionTerminated Event Subscription SOAP message template.19G.2 Template of positive response to the event subscription.19G.3 Template of negative response to the event subscription.20G.4 Template of Unsubscribe message.20G.5 Template of positive response to Unsubscribe message.21Annex H(informative)Summary of Changes.22 ISO/IEC 25437:2012(E)ISO/IEC 2012 All rights reserved v Foreword ISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of ISO or IEC participate in the development of International Standards through technical committees established by the respective organization to deal with particular fields of technical activity.ISO and IEC technical committees collaborate in fields of mutual interest.Other international organizations,governmental and non-governmental,in liaison with ISO and IEC,also take part in the work.In the field of information technology,ISO and IEC have established a joint technical committee,ISO/IEC JTC 1.International Standards are drafted in accordance with the rules given in the ISO/IEC Directives,Part 2.The main task of the joint technical committee is to prepare International Standards.Draft International Standards adopted by the joint technical committee are circulated to national bodies for voting.Publication as an International Standard requires approval by at least 75%of the national bodies casting a vote.Attention is drawn