ISO_IEC_23917_2005E.pdf

Reference numberISO/IEC 23917:2005(E)ISO/IEC 2005 INTERNATIONAL STANDARD ISO/IEC23917First edition2005-11-01 Information technology Telecommunications and information exchange between systems NFCIP-1 Protocol Test Methods Technologies de linformation Tlcommunications et change dinformation entre systmes NFCIP-1 Mthodes dessai du protocole ISO/IEC 23917:2005(E)PDF disclaimer This PDF file may contain embedded typefaces.In accordance with Adobes licensing policy,this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing.In downloading this file,parties accept therein the responsibility of not infringing Adobes licensing policy.The ISO Central Secretariat accepts no liability in this area.Adobe is a trademark of Adobe Systems Incorporated.Details of the software products used to create this PDF file can be found in the General Info relative to the file;the PDF-creation parameters were optimized for printing.Every care has been taken to ensure that the file is suitable for use by ISO member bodies.In the unlikely event that a problem relating to it is found,please inform the Central Secretariat at the address given below.ISO/IEC 2005 All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission in writing from either ISO at the address below or ISOs member body in the country of the requester.ISO copyright office Case postale 56 CH-1211 Geneva 20 Tel.+41 22 749 01 11 Fax +41 22 749 09 47 E-mail copyrightiso.org Web www.iso.org Published in Switzerland ii ISO/IEC 2005 All rights reserved ISO/IEC 23917:2005(E)ISO/IEC 2005 All rights reservediiiContentsPage1 Scope.12 Conformance.13 Normative references.14 Notational conventions.14.1 Representation of numbers.14.2 Names.14.3 Test report.25 Terms and definitions.25.1 Activation in Active communication Mode.25.2 Activation in Passive communication Mode.25.3 Active communication Mode.25.4 Operating volume.25.5 Passive communication Mode.25.6 Single Device Detection(SDD).25.7 Scenario.25.8 Test commands.26 Acronyms and abbreviations.37 General description.57.1 Apparatus for Testing.57.1.1 Generating the I/O character timing in reception mode.57.1.2 Measuring and monitoring the RF I/O protocol.57.1.3 Test scenario and report.57.1.4 RFU bits.57.1.5 General rules.58 Target test methods.58.1 Apparatus for testing the Target(Target-test-apparatus).58.2 List of protocol test methods related to ISO/IEC 18092.68.3 Activation in Passive communication Mode at 212 and 424 kbps.78.3.1 Activation time.78.3.2 Frame format.88.3.3 SDD at 212 and 424 kbps.88.4 Activation in Active communication Mode.98.4.1 RF Collision Avoidance.98.5 Logical operation of the Target Transport Protocol.108.5.1 Handling of ATR_REQ.108.5.2 Handling of PSL_REQ.118.5.3 Handling of DEP_REQ Information PDUs.138.5.4 Handling of DEP_REQ Information PDUs with the more information bit set to ONE.148.5.5 Handling of DEP_REQ supervisory PDUs with timeout bit set to ONE.198.5.6 Handling of DEP_REQ supervisory PDUs with timeout bit set to ZERO.208.5.7 Handling of DSL_REQ.218.5.8 Handling of RLS_REQ.228.5.9 Handling of WUP_REQ(Active communication Mode Only).249 Initiator test methods.269.1 Apparatus for testing the Initiator(Initiator-test-apparatus).269.1.1 Initiator test apparatus concept.26Foreword.vIntroduction.viISO/IEC 23917:2005(E)iv ISO/IEC 2005 All rights reserved9.1.4 Protocol activation procedures for Active communication Mode.279.2 List of protocol test methods for Initiators.279.3 Activation in Passive communication Mode at 212 and 424 kbps.289.3.1 Frame format.289.3.2 SDD at 212 and 424 kbps.289.4 Activation in Active communication Mode.299.4.1 Initial RF Collision Avoidance.299.4.2 Response RF Collision Avoidance with time jitter n=0.299.5 Logical operation of the Transport Protocol.309.5.1 Handling of ATR_RES.309.5.2 Handling of PSL_RES.319.5.3 Handling of DEP_RES Information PDUs.329.5.4 Handling of DEP_RES Information PDUs with more information bit set to ONE.349.5.5 Handling of DEP_RES supervisory PDUs with timeout bit set to ONE.379.5.6 Handling of DEP_RES supervisory PDUs with timeout bit set to ZERO.399.5.7 Handling of DSL_RES.409.5.8 Handling of RLS_RES.41Annex A(normative)Test report template for Target tests.43Annex B(normative)Test report template for Initiator tests.489.1.2 Protocol activation procedure for Passive communication Mode at 106 kbps.269.1.3 Protocol activation procedures for Passive communication Mode at 212 and 424 kbps.27ISO/IEC 23917:2005(E)ISO/IEC 2005 All rights reservedvForewordISO(the International Organization for Standardization)and IEC(the International Electrotechnical Commission)form the specialized system for worldwide standardization.National bodies that are members of ISO or IEC participate in the developme