IEC_60371-3-9-1995_amd1-2007.pdf

INTERNATIONAL STANDARD IEC60371-3-9 1995AMENDMENT 12007-04 Amendment 1 Insulating materials based on mica Part 3:Specifications for individual materials Sheet 9:Moulding micanite Reference number IEC 60371-3-9 Amend.1:2007(E)LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2007 IEC,Geneva,Switzerland All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission in writing from either IEC or IECs member National Committee in the country of the requester.If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,please contact the address below or your local IEC member National Committee for further information.IEC Central Office 3,rue de Varemb CH-1211 Geneva 20 Switzerland Email:inmailiec.ch Web:www.iec.ch About the IEC The International Electrotechnical Commission(IEC)is the leading global organization that prepares and publishes International Standards for all electrical,electronic and related technologies.About IEC publications The technical content of IEC publications is kept under constant review by the IEC.Please make sure that you have the latest edition,a corrigenda or an amendment might have been published.?Catalogue of IEC publications:www.iec.ch/searchpub The IEC on-line Catalogue enables you to search by a variety of criteria(reference number,text,technical committee,).It also gives information on projects,withdrawn and replaced publications.?IEC Just Published:www.iec.ch/online_news/justpub Stay up to date on all new IEC publications.Just Published details twice a month all new publications released.Available on-line and also by email.?Customer Service Centre:www.iec.ch/webstore/custserv If you wish to give us your feedback on this publication or need further assistance,please visit the Customer Service Centre FAQ or contact us:Email:csciec.ch Tel.:+41 22 919 02 11 Fax:+41 22 919 03 00 LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.INTERNATIONAL STANDARD IEC60371-3-9 1995AMENDMENT 12007-04 Amendment 1 Insulating materials based on mica Part 3:Specifications for individual materials Sheet 9:Moulding micanite D For price,see current cataloguePRICE CODE Commission Electrotechnique InternationaleInternational Electrotechnical Commission LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2 60371-3-9 Amend 1 IEC:2007(E)FOREWORD This amendment has been prepared by IEC technical committee 15:Solid electrical insulating materials.The text of this amendment is based on the following documents:FDIS Report on voting 15/362/FDIS 15/379/RVD Full information on the voting for the approval of this amendment can be found in the report on voting indicated in the above table.A bilingual version of this publication may be issued at a later date.The committee has decided that the contents of this amendment and the base publication will remain unchanged until the maintenance result date indicated on the IEC web site under http:/webstore.iec.ch in the data related to the specific publication.At this date,the publication will be reconfirmed,withdrawn,replaced by a revised edition,or amended._ Throughout the text,add 60000 to each IEC standard reference number:for example replace IEC 371-3-2 by IEC 60371-3-2.Page 5 INTRODUCTION Replace the existing text by the following new text:This part of IEC 60371 forms part of a series which deals with insulating materials built up from mica splittings or mica paper,with or without reinforcement,and with mica paper in its pure state for use in electrical equipment.IEC 60371 consists of three parts under the main title Insulating materials based on mica:Part 1:Definitions and general requirements Part 2:Methods of test Part 3:Specifications for individual materials This standard contains one of the sheets comprising Part 3:Sheet 9:Moulding micanite.LICENSED TO MECON Limited.-RANCHI/BANGALORE,FOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.60371-3-9 Amend 1 IEC:2007(E)3 Page 7 1 Scope Insert the following new text:Safety warning It is the responsibility of the user of the methods contained or referred to in this document to ensure that they are used in a safe manner.2 Normative references Replace the whole of this clause by the following:The following referenced documents are indispensable for the application of this document.For dated references,only the edition cited applies.For undated references,the latest edition of the referenced document(including any amendments)applies.IEC 60243-1:1998,Electrical strength of insulating materials Test methods Part 1:Tests at power frequencies IEC 60371-2:2004,Specificatio