IEC_60169-9-1978_amd1-1996_scan.pdf

NORMEINTERNATIONALEINTERNATIONALSTANDARDCEIIEC169-9QC 2214001978AMENDEMENT 1AMENDMENT 11996-03Amendement 1Connecteurs pour frquences radiolectriquesPartie 9:Connecteurs coaxiaux pour frquencesradiolectriques avec diamtre intrieur duconducteur extrieur de 3 mm(0,12 in)verrouillage vis-Impdance caractristique 50 ohms(type SMC)Amendment 1Radio-frequency connectorsPart 9:RF coaxial connectors with inner diameterof outer conductor 3 mm(0,12 in)with screw coupling-Characteristic impedance 50 ohms(type SMC)CEI 1996 Droits de reproduction rservs Copyright all rights reservedBureau Central de la Commission Electrotechnique Internationale 3,rue de Varemb Genve,SuisseIECCommission Electrotechnique InternationaleInternational Electrotechnical CommissionMentaHapoAHas 3neltrporexHHVeclaa HOMHCCHH?CODE PRIXPRICE CODEPour prix,voir catalogue en vigueurFor price,see current catalogueLICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2?169-9 amend.1 C El:1996AVANT-PROPOSLe prsent amendement a t tabli par le sous-comit 46D:Connecteurs pour frquencesradiolectriques,du comit dtudes 46 de la CEI:Cbles,fils,guides dondes,connec-teurs et accessoires pour communications et signalisation.Le texte de cet amendement est issu des documents suivants:FDISRapports de vote46D/142/FDIS46D/154/RVD46D/148/FDIS46D/186/RVD46D/149/FDIS46D/171/RVD46D/161/FDIS46D/191/RVDLes rapports de vote indiqus dans le tableau ci-dessus donnent toute information sur levote ayant abouti lapprobation de cet amendement.Page 2SOMMAIREAjouter le titre de larticle 10 suivant:10 Procdures dassurance de la qualitPage 10Remplacer larticle 5 existant par le nouvel article suivant:5 Dimensions Connecteurs dusage gnral(classe 2)Les dimensions en inches sont les dimensions originales.Toutes les reprsentations noncotes sont donnes pour rfrence uniquement.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.169-9 Amend.1 I EC:1996?3 FOREWORDThis amendment has been prepared by subcommittee 46D:R.F.connectors,of IEC technicalcommittee 46:Cables,wires,waveguides,r.f.connectors,and accessories for communicationand signalling.The text of this amendment is based on the following documents:FDISReports on voting46D/142/FDIS46D/154/RVD46D/148/FDIS46D/186/RVD46D/149/FDIS46D/171/RVD46D/161/FDIS46D/191/RVDFull information on the voting for the approval of this amendment can be found in thereports on voting indicated in the above table.Page 3CONTENTSAdd the title of clause 10 as follows:10 Quality assessment proceduresPage 10Replace the existing clause by the following new clause:5 Dimensions General purpose connectors(grade 2)Inch dimensions are original dimensions.All undimensioned pictorial configurations are forreference purposes only.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.-4-?169-9 amend.1 CEI:19965.1 Connecteur mle 10-32 UNF-2A n?/EC 179/96Figure 1RfrencemminchNoteMin.Max.Min.Max.a3,710,146diamtrec2,080,082diamtred2e0,480,530,0190,021diamtref0,250,010g3,400,134h3,400,134k0,0000,000m3,123,380,1230,133n5,940,2341p0,610,024q2,130,084s3,050,120diamtre nom.NOTES1 Longueur minimale de filetage.2 Diamtre choisi pour obtenir limpdance de 50 S2.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.169-9 Amend.1 I EC:1996?-5-5.1 Connector with pin centre contactm 10-32 U N F-2A n?!EC!74/96Figure 1ReferencemminchNoteMin.Max.Min.Max.a3,710,146diameterc2,080,082diameterd2e0,480,530,0190,021diameterf0,250,010g3,400,134h3,400,134k0,0000,000m3,123,380,1230,133n5,940,2341p0,610,024q2,130,084s3,050,120diameter nom.NOTES1 Thread gauge to go this minimum distance.2 Chosen diameter to give required 50 i2 impedance.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.f10-32 UNF-2B-6-?169-9 amend.1 CEI:19965.2 Connecteurs avec contact central femellet%j.rj c:?.N!3?.!llll i1:5maPlan de rfrence+?nIEC I80/96Figure 2RfrencemminchNoteMin.Max.Min.Max.a3,730,147diamtreb3,070,1215?diamtrec2,060,081diamtred4e3f1g3,400,134h2,853,400,1120,134k0,000,000m2,790,110n5,920,2332p2,790,110u3,100,122s3,050,120diamtre nom.NOTES1 Mthode de la fente facultative.Resserrement du contact femelle pour respecter les prescriptionslectriques et mcaniques.2 Dimension quand lcrou daccouplement est positionn en avant.3 Diamtre dalsage pour satisfaire aux prescriptions lectriques et mcaniques.4 Diamtre choisi pour obtenir limpdance de 50 S2.5 Applicable partir du plan de rfrence.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.f10-32 UNF-2B169-9 Amend.1 IEC:1996?-7-5.2 Connector with socket centre contact_s:r.,%j:._.s0?=1=1iTReference planenIEC I80i96Figure 2ReferencemminchNoteMin.Max.Mn.Max.a3,730,147diameterb3,070,1215 diameterc2,060,081diameterd4e3f1g3,400,134h2