IEC_60264-3-3-1990_amd1-2003.pdf

NORME INTERNATIONALE CEIIEC INTERNATIONAL STANDARD 60264-3-31990-07AMENDEMENT 1AMENDMENT 12003-12 Amendement 1 Conditionnement des fils de bobinage Partie 3-3:Bobines de livraison ft de forme conique Spcification pour les bobines non rutilisables,faites de matriau thermoplastique Amendment 1 Packaging of winding wires Part 3-3:Taper barrelled delivery spools Specification for non-returnable spools made from thermoplastic material Pour prix,voir catalogue en vigueur For price,see current catalogue IEC 2003 Droits de reproduction rservs Copyright-all rights reserved International Electrotechnical Commission,3,rue de Varemb,PO Box 131,CH-1211 Geneva 20,SwitzerlandTelephone:+41 22 919 02 11 Telefax:+41 22 919 03 00 E-mail:inmailiec.ch Web:www.iec.ch Commission Electrotechnique InternationaleInternational Electrotechnical Commission C CODE PRIX PRICE CODE LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.2 60264-3-3 Amend.1 CEI:2003 AVANT-PROPOS Le prsent amendement a t tabli par le comit dtudes 55 de la CEI:Fils de bobinage.Le texte de cet amendement est issu des documents suivants:FDIS Rapport de vote 55/871/FDIS 55/888/RVD Le rapport de vote indiqu dans le tableau ci-dessus donne toute information sur le vote ayant abouti lapprobation de cet amendement.Le comit a dcid que le contenu de la publication de base et de ses amendements ne sera pas modifi avant 2009.A cette date,la publication sera reconduite;supprime;remplace par une dition rvise,ou amende._ Page 6 INTRODUCTION Remplacer le texte existant par ce qui suit:Cette partie de la CEI 60264 constitue lun des lments dune srie traitant des fils isols utiliss dans les enroulements des appareils lectriques.Cette srie comporte trois groupes dfinissant respectivement:1)les fils de bobinage Mthodes dessai(CEI 60851);2)les spcifications pour types particuliers de fils de bobinage(CEI 60317);3)le conditionnement de fils de bobinage(CEI 60264).Page 8 2 Rfrences normatives Remplacer la rfrence CEI 60264-4-1:1989 par CEI 60264-4-1:1997.4 Dsignation du type Dans le dernier alina,remplacer la dsignation 264-3-3/IEC 250/400 par IEC 60264-3-3/IEC 250/400.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.60264-3-3 Amend.1 IEC:2003 3 FOREWORD This amendment has been prepared by IEC technical committee 55:Winding wires.The text of this amendment is based on the following documents:FDIS Report on voting 55/871/FDIS 55/888/RVD Full information on the voting for the approval of this amendment can be found in the report on voting indicated in the above table.The committee has decided that the contents of the base publication and its amendments will remain unchanged until 2009.At this date,the publication will be reconfirmed;withdrawn;replaced by a revised edition,or amended._ Page 7 INTRODUCTION Replace the existing text by the following:This part of IEC 60264 is one of a series that deals with insulated wires used for winding in electrical equipment.The series comprises three groups:1)winding wires Test methods(IEC 60851);2)specifications for particular types of winding wires(IEC 60317);3)packaging of winding wires(IEC 60264).Page 9 2 Normative references Replace the reference“IEC 60264-4-1:1989”by“IEC 60264-4-1:1997”.4 Type designation In the last paragraph,replace the designation“264-3-3/IEC 250/400”by“IEC 60264-3-3/IEC 250/400”.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.4 60264-3-3 Amend.1 CEI:2003 Page 10 5.2 Marquage des bobines En 5.2 a),remplacer la dsignation 264-3-3/IEC 250/400 par IEC 60264-3-3/IEC 250/400.Le changement ne sapplique pas au texte franais.Page 12 5.6 Tenue sous temprature leve Dans le premier alina,remplacer une temprature de 50 3 C par une temprature de(60 3)C.5.7.1 En conditions ambiante normales Au Tableau 2,remplacer len-tte Energie N.m par Energie Nm._ LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.60264-3-3 Amend.1 IEC:2003 5 Page 11 5.2 Spool marking In 5.2 a),replace the designation“264-3-3/IEC 250/400”by“IEC 60264-3-3/IEC 250/400”.In the last paragraph,penultimate line,replace“the weight”by“the mass”.Page 13 5.6 Behaviour at high temperature In the first paragraph,replace“at a temperature of 50 3 C”by“at a temperature of (60 3)C”.5.7.1 Under normal ambient conditions In Table 2,replace the header“Energy N.m”by“Energy Nm”._ LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.ISBN 2-8318-7324-X-:HSMINB=XWYY:ICS 29.060.10 Typeset and printed by the IEC Central Office GENEVA,SWITZERLAND LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.