IEC_61000-4-23-2016.pdf

IEC 61000-4-23 Edition 2.0 2016-10 INTERNATIONAL STANDARD Electromagnetic compatibility(EMC)Part 4-23:Testing and measurement techniques Test methods for protective devices for HEMP and other radiated disturbances IEC 61000-4-23:2016-10(en)BASIC EMC PUBLICATION colourinside THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright 2016 IEC,Geneva,Switzerland All rights reserved.Unless otherwise specified,no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical,including photocopying and microfilm,without permission in writing from either IEC or IECs member National Committee in the country of the requester.If you have any questions about IEC copyright or have an enquiry about obtaining additional rights to this publication,please contact the address below or your local IEC member National Committee for further information.IEC Central Office Tel.:+41 22 919 02 11 3,rue de Varemb Fax:+41 22 919 03 00 CH-1211 Geneva 20 infoiec.ch Switzerland www.iec.ch About the IEC The International Electrotechnical Commission(IEC)is the leading global organization that prepares and publishes International Standards for all electrical,electronic and related technologies.About IEC publications The technical content of IEC publications is kept under constant review by the IEC.Please make sure that you have the latest edition,a corrigenda or an amendment might have been published.IEC Catalogue-webstore.iec.ch/catalogue The stand-alone application for consulting the entire bibliographical information on IEC International Standards,Technical Specifications,Technical Reports and other documents.Available for PC,Mac OS,Android Tablets and iPad.IEC publications search-www.iec.ch/searchpub The advanced search enables to find IEC publications by a variety of criteria(reference number,text,technical committee,).It also gives information on projects,replaced and withdrawn publications.IEC Just Published-webstore.iec.ch/justpublished Stay up to date on all new IEC publications.Just Published details all new publications released.Available online and also once a month by email.Electropedia-www.electropedia.org The worlds leading online dictionary of electronic and electrical terms containing 20 000 terms and definitions in English and French,with equivalent terms in 15 additional languages.Also known as the International Electrotechnical Vocabulary(IEV)online.IEC Glossary-std.iec.ch/glossary 65 000 electrotechnical terminology entries in English and French extracted from the Terms and Definitions clause of IEC publications issued since 2002.Some entries have been collected from earlier publications of IEC TC 37,77,86 and CISPR.IEC Customer Service Centre-webstore.iec.ch/csc If you wish to give us your feedback on this publication or need further assistance,please contact the Customer Service Centre:csciec.ch.IEC 61000-4-23 Edition 2.0 2016-10 INTERNATIONAL STANDARD Electromagnetic compatibility(EMC)Part 4-23:Testing and measurement techniques Test methods for protective devices for HEMP and other radiated disturbances INTERNATIONAL ELECTROTECHNICAL COMMISSION ICS 33.100.99 ISBN 978-2-8322-3687-1 BASIC EMC PUBLICATION Registered trademark of the International Electrotechnical Commission Warning!Make sure that you obtained this publication from an authorized distributor.colourinside 2 IEC 61000-4-23:2016 IEC 2016 CONTENTS FOREWORD.6 INTRODUCTION.8 1 Scope.9 2 Normative references.9 3 Terms and definitions.10 4 HEMP test concepts.15 4.1 General.15 4.2 Testing of shielding enclosures.16 4.2.1 General.16 4.2.2 Buildings.19 4.2.3 Shelters and shielded rooms.20 4.2.4 Cabinets,racks and boxes.21 4.3 Testing of shielded cables and connectors.23 4.3.1 General.23 4.3.2 Testing of cable shields.23 4.3.3 Testing of cable connectors.26 4.4 Testing of shielding materials.27 4.4.1 General.27 4.4.2 Conducting gaskets.27 4.4.3 Conducting sheets and screens.29 4.4.4 Cut-off waveguides and honeycombs.32 4.5 Summary of test concepts.33 5 Test methods for measuring the shielding effectiveness of HEMP protection facilities.34 5.1 General.34 5.2 Electromagnetic field testing.34 5.2.1 General.34 5.2.2 Pulse field testing.34 5.2.3 CW field testing.40 5.3 Current injection test procedures.55 5.3.1 General.55 5.3.2 Injection testing of enclosures.55 5.3.3 Transfer impedance and admittance of cable shields and connectors.57 5.3.4 Testing of gasket material.57 Annex A(informative)HEMP test concepts for electrical systems.60 A.1 Overview.60 A.2 Types of HEMP tests.60 A.2.1 General.60 A.2.2 System-level transient tests.60 A.2.3 CW field illumination tests.61 A.2.4 Current injection testing.61 A.2.5 Partial illumination testing.62 A.2.6 Subsystem and component testing.62 A.3 Definition of the testing interface.63 A.4 Use of test data.65 A.4.1 General.65 IEC 61000-4-23:2016 IEC 2016 3 A.4.2 Acceptance of new systems.65 A.4.3 System assessments.65 A.4.4 Hardness surveillance monitoring.65 A.4.5 System design.65 A.5 Testing unce