温馨提示:
1. 部分包含数学公式或PPT动画的文件,查看预览时可能会显示错乱或异常,文件下载后无此问题,请放心下载。
2. 本文档由用户上传,版权归属用户,汇文网负责整理代发布。如果您对本文档版权有争议请及时联系客服。
3. 下载前请仔细阅读文档内容,确认文档内容符合您的需求后进行下载,若出现内容与标题不符可向本站投诉处理。
4. 下载文档时可能由于网络波动等原因无法下载或下载错误,付费完成后未能成功下载的用户请联系客服处理。
网站客服:3074922707
IEC_60598
1987
_amd1
1993
_scan
NORME?CEIINTERNATIONALE?I ECINTERNATIONAL?598-2-9STANDARD?1987AMENDEMENT 1AMENDMENT11993-06Amendement 1LuminairesPartie 2:Rgles particuliresSection 9:Luminaires pour prises de vuesphotographiques et cinmatographiques(non professionnels)Amendment 1LuminairesPart 2:Particular requirementsSection 9:Photo and film luminaires(non-professional)CEI 1993 Droits de reproduction rservs Copyright all rights reservedBureau Central de la Commission Electrotechnique Internationale 3,rue de Varemb Genve,SuisseIECCommission Electrotechnique Internationale CODE PRIXInternational Electrotechnical Commission PRICE CODEMenwwHaponNas 3neerposexHN4ecpa KOMNCCNAPour prix,voir catalogue en vigueurFor price,see current catalogueLICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.34D(BC)21534D(BC)236Rgle des Six MoisRapport de vote-2-?598-2-9 amend.1 CEI:1993AVANT-PROPOSLe prsent amendement a t tabli par le sous-comit 34D:Luminaires,du comitdtudes 34 de la CEI:Lampes et quipements associs.Le texte de cet amendement est issu des documents suivants:Le rapport de vote indiqu dans le tableau ci-dessus donne toute information sur le voteayant abouti lapprobation de cet amendement.9.1 Domaine dapplicationAjouter les mots suivants la fin du premier paragraphe ou la dsignation de la seulelampe utilisable.9.5 MarquageRemplacer le premier paragraphe par:Les dispositions et position de marquage de la section trois de la CEI 598-1 sontapplicables en mme temps que les prescriptions des paragraphes 9.5.1 9.5.5.9.5.5?Point 1),ajouter.Feuille 357-IEC-3155 ou la dsignation de la seule lampeutilisable.Modification au paragraphe 9.10.1 Cblage externe et interne9.10.1 Cblage externe et interneRemplacer,page 15,les paragraphes 4 6 par le contrle suivant:Le cble ou cordon est charg avec un poids tel que la force applique est de 20 N.Un courant dont la valeur est dduite de la puissance maximale nominale et de la tensionnominale,traverse les conducteurs,la tension entre les contacts de la douille tant gale la tension nominale.La partie oscillante est dplace en arrire et en avant dans un angle de 90(45 dechaque ct de la verticale),le nombre de flexions tant de 20 000 et le taux de flexion60 par minute.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.Six Months RuleReport on Voting34D(CO)21534D(CO)236598-2-9 Amend.1 IEC:1993?-3-FOREWORDThis amendment has been prepared by sub-committee 34D:Luminaires,of IEC technicalcommittee 34:Lamps and related equipment.The text of this amendment is based on the following documents:Full information on the voting for the approval of this amendment can be found in theVoting Report indicated in the above table.9.1 ScopeAdd the following words at the end of the first paragraph or unique lamp designation.9.5 MarkingReplace the first paragraph by:The provisions and position of marking of Section Three of IEC 598-1 apply together withthe requirements of subclauses 9.5.1 to 9.5.5.9.5.5 Item 1),add:.Sheet 357-IEC-3155 or unique lamp designation.Amendment to 9.10.1 External and internal wiring.9.10.1 External and internal wiringReplace,on page 15,paragraphs 4 to 6 by the following compliance:The cable or cord is loaded with a weight such that the force applied is 20 N.A current,the value of which is derived from the maximum rated wattage and rated vol-tage,is passed through the conductors,the voltage between the contacts of thelampholder being equal to the rated voltage.The oscillating member is moved backwards and forwards through an angle of 90(45 oneither side of the vertical),the number of flexings being 20 000 and the rate of flexing 60per minute.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.4?598-2-9 amend.1 CEI:1993Aprs lessai,pas plus de 50%des brins de lme du conducteur ne doivent tre rompuset le cble ou cordon doit tre soumis et doit satisfaire aux essais de rsistancedisolement et de haute tension de la section dix de la CEI 598-1.NOTE-Une flexion est un mouvement,soit en arrire ou en avant.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.598-2-9 Amend.1 IEC:1993?5 After the test,not more than 50%of the strands in a conductor shall be broken and thecord or cable shall be subject to,and shall satisfy,the insulation resistance and high-voltage tests specified in Section Ten of IEC 598-1.NOTE-A flexing is one movement,either backwards or forwards.LICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.ICS 29.140.40Typeset and printed by the IEC Central OfficeGENEVA,SWITZERLANDLICENSED TO MECON Limited.-RANCHI/BANGALOREFOR INTERNAL USE AT THIS LOCATION ONLY,SUPPLIED BY BOOK SUPPLY BUREAU.