_STP_1539-2011.pdf

JAI Guest Editors:Ashok SaxenaBilal DoganJournal of ASTM InternationalSelected Technical Papers STP 1539Creep-Fatigue InteractionsTest Methods and Modelswww.astm.orgISBN:978-0-8031-7525-9Stock#:STP1539JAI Creep-Fatigue Interactions:Test Methods and ModelsSTP 1539Saxena|Dogan Journal of ASTM International Selected Technical Papers STP1539Creep-Fatigue Interactions:Test Methods and ModelsJAI Guest Editors:Ashok SaxenaBilal DoganASTM International100 Barr Harbor DrivePO Box C700West Conshohocken,PA 19428-2959Printed in the U.S.A.ASTM Stock#:STP1539 Library of Congress Cataloging-in-Publication DataISSN:978-0-8031-7525-9Copyright 2011 ASTM INTERNATIONAL,West Conshohocken,PA.All rights reserved.This material may not be reproduced or copied,in whole or in part,in any printed,mechanical,electronic,fi lm,or other distribution and storage media,without the written consent of the publisher.Journal of ASTM International(JAI)ScopeThe JAI is a multi-disciplinary forum to serve the international scientifi c and engineering community through the timely publication of the results of original research and critical review articles in the physical and life sciences and engineering technologies.These peer-reviewed papers cover diverse topics relevant to the science and research that establish the foundation for standards development within ASTM International.Photocopy RightsAuthorization to photocopy items for internal,personal,or educational classroom use,or the internal,personal,or educational classroom use of specifi c clients,is granted by ASTM International provided that the appropriate fee is paid to ASTM International,100 Barr Harbor Drive,P.O.Box C700,West Conshohocken,PA 19428-2959,Tel:610-832-9634;online:http:/www.astm.org/copyright.The Society is not responsible,as a body,for the statements and opinions expressed in this publication.ASTM International does not endorse any products represented in this publication.Peer Review PolicyEach paper published in this volume was evaluated by two peer reviewers and at least one editor.The authors addressed all of the reviewers comments to the satisfaction of both the technical editor(s)and the ASTM International Committee on Publications.The quality of the papers in this publication refl ects not only the obvious efforts of the au-thors and the technical editor(s),but also the work of the peer reviewers.In keeping with long-standing publication practices,ASTM International maintains the anonymity of the peer reviewers.The ASTM International Committee on Publications acknowledges with appreciation their dedication and contribution of time and effort on behalf of ASTM International.Citation of PapersWhen citing papers from this publication,the appropriate citation includes the paper authors,“paper title”,J.ASTM Intl.,volume and number,Paper doi,ASTM International,West Conshohocken,PA,Paper,year listed in the footnote of the paper.A citation is provided as a footnote on page one of each paper.November,2011Printed in Swedesboro,NJ ForewordTHIS COMPILATION OF THE JOURNAL OF ASTM INTERNATIONAL(JAI),STP1539,Creep-Fatigue Interactions:Test Methods and Models,contains only the papers published in JAI that were presented at a Symposium on Creep-Fatigue Interactions:Test Methods and Models held during November 1719,2010 in San Antonio,TX,USA.The Symposium was sponsored by ASTM International Committee E08 on Fatigue and Fracture in cooperation with ICF and EPRI.Dr.Ashok Saxena,University of Arkansas,Fayetteville,AR,USA and Dr.Bilal Dogan,EPRI,Charlotte,NC,USA served as the Symposium Co-Chairmen and JAI Guest Editors.ContentsOverview.viiPart I-Creep-fatigue Interactions in Ferritic and Austenitic SteelsComponent Assessment Data Requirements from Creep-Fatigue TestsS.R.Holdsworth.3ASTM Round-Robin on Creep-Fatigue and Creep Behavior of P91 SteelV.Kalyanasundaram,A.Saxena,S.Narsimhachary,and B.Dogan.23Evaluation of the Testing and Analysis Methods in ASTM E2760-10 Creep-Fatigue Crack Growth Testing Standard for a Range of SteelsA.Mehmanparast,C.M.Davies,and K.M.Nikbin.41Characterizations of Creep-fatigue Crack Initiation and Growth Life for P92 using Circular Notched Round Bar SpecimenR.Sugiura,A.T.Yokobori,Jr.,T.Nakagawa,T.Adachi,I.Nonaka,M.Tabuchi,Y.Hasegawa,and T.Matsuzaki.67Creep Fatigue Behavior of Creep Strength Enhanced Ferritic SteelsJ.Parker.87Advanced Ductility Exhaustion Methods for the Calculation of Creep Damage During Creep-fatigue CyclingM.W.Spindler and W.M.Payten.102Modeling Creep-Fatigue Behavior of Mod.9Cr-1Mo SteelM.Li,S.Majumdar,and K.Natesan.128Models for Small Crack Growth under Creep-Fatigue in Austenitic SteelsR.P.Skelton.142Effect of Creep and Oxidation on the Isothermal and Thermomechanical Fatigue Behavior of an Austenitic Stainless SteelH.-J.Christ and V.Bauer.178Creep Crack Growth Under Complex LoadingR.A.Ainsworth,D.W.Dean,and P.J.Budden.198Probabilistic Prediction of Crack Growth Based on Creep/Fatigue Damage Accumulation MechanismZ.Wei,F.Yang,H.Cheng,and K.Ni