_STP_1329-1998.pdf

STP 1329 Small Specimen Test Techniques William R.Corwin,Stan T.Rosinski,and Eric van Walle,editors ASTM Stock#:STP1329 ASTM 100 Barr Harbor Drive West Conshohocken,PA 19428-2959 Printed in the U.S.A.Copyright by ASTM Intl(all rights reserved);Wed Dec 23 19:46:20 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Library of Congress Cataloging-in-Publication Data Small specimen test techniques/William R.Corwin,Stan T.Rosinski,and Eric van Walle,editors(STP:1329)ASTM stock#:STP1329.Papers presented at the symposium of the same name held in New Orleans,Louisiana,on 13-14 January 1997;sponsored by ASTM Committee E-10 on Behavior and Use of Nuclear Structural Materials.Includes bibliographical references and index.ISBN 0-8031-2476-7 1.Notched bar testing.2.Light water reactors-Materials-Testing.3.Metals-Embrittlement.I.Corwin,W.R.I1.Rosinski,Stan T.,1960-Ill.Walle,E.van(Eric)W.ASTM Committee E-10 on Behavior and Use of Nuclear Structural Materials.V.Series:ASTM special technical publication;1329.TA418.34.S63 1998 621.4833-dc21 98-25686 CIP Copyright?9 1998 by the AMERICAN SOCIETY FOR TESTING AND MATERIALS,West Conshohocken,PA.All rights reserved.This material may not be reproduced or copied,in whole or in part,in any printed,mechanical,electronic,film,or other distribution and storage media,without the written consent of the publisher.Photocopy Rights Authorization to photocopy items for internal,personal,or educational classroom use,or the internal,personal,or educational classroom use of specific clients,is granted by the American Society for Testing and Materials(ASTM)provided that the appropriate fee is paid to the Copyright Clearance Center,222 Rosewood Drive,Dan-vers,MA 01923;Tel:508-750-8400;online:http:l.Peer Review Policy Each paper published in this volume was evaluated by two peer reviewers and at least one of the editors.The authors addressed all of the reviewers comments to the satisfaction of both the technical editor(s)and the ASTM Committee on Publications.To make technical information available as quickly as possible,the peer-reviewed papers in this publication were prepared camera-ready as submitted by the authors.The quality of the papers in this publication reflects not only the obvious efforts of the authors and the technical editor(s),but also the work of these peer reviewers.The ASTM Committee on Publications acknowledges with appreciation their dedication and contribution to time and effort on behalf of ASTM.Printed in Philadelphia,PA July,1998 Copyright by ASTM Intl(all rights reserved);Wed Dec 23 19:46:20 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Foreword This publication,Small Specimen Test Techniques,contains papers presented at the symposium of the same name held in New Orleans,Louisiana,on 13-14 January 1997.The symposium was sponsored by ASTM Committee E-10 on Behavior and Use of Nuclear Structural Materials,in cooperation with the European Network on Aging Materials Evalu-ation and Studies(AMES)and the TC5 Technical Subcommittee on Dynamic Testing at Intermediate Strain Rates of the European Structural Integrity Society(ESIS).The sympo-sium chairman was William R.Corwin,Oak Ridge National Laboratory.Copyright by ASTM Intl(all rights reserved);Wed Dec 23 19:46:20 EST 2015Downloaded/printed byUniversity of Washington(University of Washington)pursuant to License Agreement.No further reproductions authorized.Contents Overview vii MINIATURE IMPACT TECHNIQUES ASTM Cross-Comparison Exercise on Determination of Material Properties Through Miniature Sample Testing-STAN T.ROSINSKI AND WILLIAM R.CORWIN Sub-Size Impact Testing:CISE Experience and the Activity of the ESIS TC5 Sub-Committee-ENRiCO LUCON Comparison of Results of Instrumental Charpy-and Mini-Charpy Tests with Different RPV-SteeIs-WOLFGANG B(3HME AND WINFRIED SCHMITT Fracture Toughness Evaluation from Instrumented Sub-Size Charpy-Type TestS-HANS J.SCHINDLER AND MARTIN VELDT Characterization of Ductile Fracture Toughness Based on Subsized Charpy and Tensile Test Results-WlNFRIED SCHMITF,HELl TALJA,WOLFGANG BOHME,SABINE OESER,AND HORST STOCKL Effects of Ligament Size and Tensile Properties on the Fracture of Pressure Vessel Materials Under Impact Loading-sCOTT E.SIDENER,ARVIND S.KUMAR,AND MARGARET L.HAMILTON Instrumented Impact Testing of Subsize Charpy V-Notch Specimens-JORG F.KALTHO AND MICHAEL GREGOR Dependence of Ductile-Brittle Transition Behavior on the Size of Charpy Specimen and the Location of V-Notch in the HAZ of Welded A533B PVS-AKIHIKO KIMURA,TETSUYA SUZUKI,MORIO JINCHO,AND HIDEKI MATSUI Analysis of Procedures for the Determination of the Yield Force(Fgy)for Instrumented Sub-Sized Charpy-V Specimens-HOWARD TAYLOR Fracture Toughness Testing of Small and Standard Bending Specimens-DIETMAR KALKHOF AND KLAUS KROMPHOLZ The Actual