分享
ASTM_F_934_-_96_2013.pdf
下载文档

ID:191266

大小:56.10KB

页数:1页

格式:PDF

时间:2023-03-04

收藏 分享赚钱
温馨提示:
1. 部分包含数学公式或PPT动画的文件,查看预览时可能会显示错乱或异常,文件下载后无此问题,请放心下载。
2. 本文档由用户上传,版权归属用户,汇文网负责整理代发布。如果您对本文档版权有争议请及时联系客服。
3. 下载前请仔细阅读文档内容,确认文档内容符合您的需求后进行下载,若出现内容与标题不符可向本站投诉处理。
4. 下载文档时可能由于网络波动等原因无法下载或下载错误,付费完成后未能成功下载的用户请联系客服处理。
网站客服:3074922707
TM_F_934_ _96_2013
Designation:F93496(Reapproved 2013)Standard Specification forStandard Colors for Polymer-Coated Chain Link FenceMaterials1This standard is issued under the fixed designation F934;the number immediately following the designation indicates the year of originaladoption or,in the case of revision,the year of last revision.Anumber in parentheses indicates the year of last reapproval.Asuperscriptepsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This specification covers standard colors for coatedchain link fence materials such as chain link fence fabric,tension wire,posts,rails,gate frames,and fittings.2.Referenced Documents2.1 ASTM Standards:2D1729 Practice for Visual Appraisal of Colors and ColorDifferences of Diffusely-Illuminated Opaque MaterialsD2244 Practice for Calculation of Color Tolerances andColor Differences from Instrumentally Measured ColorCoordinatesG90 Practice for Performing Accelerated Outdoor Weather-ing of Nonmetallic Materials Using Concentrated NaturalSunlight3.Color3.1 Unless otherwise stipulated by the purchaser,determinethe color in accordance with the standard contained in Table 1.3.2 Determine compliance with this requirement by com-parison of specimens of the coated materials to standard flatspecimens of fused film of approximately the thickness speci-fied for the coating to be applied to the materials,andmeasuring at least 112by 112in.(38 by 38 mm).3.3 Prepare standard flat specimens for the evaluation ofcolor coating by duplicating the production process as nearly aspossible including temperature,particle size,etc.3.4 Determine the color of the standard flat specimens inaccordance with Test Method D2244 and Practice D1729.3.5 Do not allow the color of the specimens to vary morethan 6 Delta E when exposed to 500 000 Langleys acceleratedweathering operated in accordance with Practice G90 with bothday and night spray cycles.TABLE 1 Standard Polymer ColorsDark GreenOlive GreenBrownBlackL28.6132.1027.7622.30A12.596.143.370.09B1.953.004.280.85Delta/E3.03.03.06.0ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard.Users of this standard are expressly advised that determination of the validity of any such patent rights,and the riskof infringement of such rights,are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised,either reapproved or withdrawn.Your comments are invited either for revision of this standard or for additional standardsand should be addressed to ASTM International Headquarters.Your comments will receive careful consideration at a meeting of theresponsible technical committee,which you may attend.If you feel that your comments have not received a fair hearing you shouldmake your views known to the ASTM Committee on Standards,at the address shown below.This standard is copyrighted by ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959,United States.Individual reprints(single or multiple copies)of this standard may be obtained by contacting ASTM at the aboveaddress or at 610-832-9585(phone),610-832-9555(fax),or serviceastm.org(e-mail);or through the ASTM website(www.astm.org).Permission rights to photocopy the standard may also be secured from the ASTM website(www.astm.org/COPYRIGHT/).1This specification is under the jurisdiction of ASTM Committee F14 on Fencesand is the direct responsibility of Subcommittee F14.40 on Chain Link Fence andWire Accessories.Current edition approved March 1,2013.Published March 2013.Originallyapproved in 1985.Last previous edition approved in 2008 as F934-96(2008).DOI:10.1520/F0934-96R13.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1

此文档下载收益归作者所有

下载文档
你可能关注的文档
收起
展开