ASTM_D_1409_-_65_1990_scan.pdf

,-ASTM D1409 65 m 0759530 0073874 8-:4Tb Designation:D 1409-65(Reapproved 1990)An American National Standard!q Lo Standard:2554 Standard Practice for Measurement and Calibration of Tank Car Tanks This praclice has been approved by the sponsoring committees and accepted by the cooperating societies in accordance with established procedures.This practice describes procedures for calibrating tank cars in two parts:Part I for nonpressure-type tank cars and Part II for pressure-type tank cars.NOTE-Other calibration standards are as follows:API Standard:2550-ASTM Methods D 1220,Measurement and Calibration of Upright Cylindrical Tanks,API Standard:255 I-ASTM Methods D 1410,Measurement and Calibration of Stationary Horizontal Tanks,API Standard:2553-ASTM Methods D 1407,Measurement and Calibration of Barge Tanks,API Standard:2554-ASTM Methods D 1409,Measurement and Calibration of Tank Car Tanks,and API Standard:2555-ASTM Methods D 1406,Liquid Calibration of Tanks.Due to the special nature of this practice,it is of interest to a limited number of the users of this book.The practice,therefore,is not included in this book.This practice will not be published by the American Society for Testing and Materials but will be published by the American Petroleum Institute.Separate copies will be available from ASTM.I This practice is under the jurisdiction of ASTM Committee D-2 on Petroleum Products and Lubricants and API Committee on Petroleum Measurement and is the direct responsibility of Subcommittee DO2.02 on Joint ASTM-API Committee on Static Petroleum Measurement.Current edition approved Aug.31,1965.Originally published 1956.Last previous edition D 1408-65(1980).549 NOTICE:This standard has either been superseded and replaced by a new version or discontinued.Contact ASTM International(www.astm.org)for the latest information.