ASTM_D_1220_-_65_1990_scan.pdf

t Designation:D 1220-65(Reapproved 1990).JJ)Standard:2550 Standard Practice for An American National Standard Measurement and Calibration of Upright Cylindrical Tanks 1 This practice has been approved by the sponsoring committees and accepted by the cooperating societies in accordance with established procedures.This practice describes the procedures for calibrating upright stationary tanks larger than a barrel or drum,which are presented in two parts:Part I outlines procedures for making necessary measurements to determine total and incremental tank volumes;Part II presents the recommended procedure for computing volumes.-NOTE-Other calibration standards are as follows:API Standard:2551-ASTM Methods D 1410,Measurement and Calibration of Stationary Horizontal Tanks,API Standard:2552-ASTM Methods D 1408,Measurement and Calibration of Spherical and Spheroidal Tanks,API Standard:2553-ASTM Methods D 1407,Measurement and Calibration of Barge Tanks,-_.API Standard:2554-ASTM Methods D 1409,Measurement and Calibration of Tank Car Tanks,and API Standard:2555-ASTM Methods D 1406,Liquid Calibration of Tanks.Due to the special nature of this practice,it is of interest to a limited number of the users of this book.The practice,therefore,is not included in this book.This practice will not be published by the American Society for Testing and Materials but will be published by the American Petroleum Institute.Separate copies will be available from ASTM.1 This practice is under the jurisdiction of ASTM Committee D-2 on Petroleum Products and Lubricants and is the direct responsibility of Subcommittee 002.02 on Static Petroleum Measurement.Current edition approved Aug.31,1965.Originally published 1952.Last previous edition D 1220-65(1980).rima mahbob(Universita degli studi di Padova)pursuant to License Agreement.No further reproductions authorized.Downloaded/printed byCopyright by ASTM Intl(all rights reserved),Mon Sep 06 16:50:02 GMT 2021NOTICE:This standard has either been superseded and replaced by a new version or discontinued.Contact ASTM International(www.astm.org)for the latest information.