分享
ASTM_D_1776_-_D_1776M_-_20.pdf
下载文档

ID:182575

大小:131.49KB

页数:5页

格式:PDF

时间:2023-03-04

收藏 分享赚钱
温馨提示:
1. 部分包含数学公式或PPT动画的文件,查看预览时可能会显示错乱或异常,文件下载后无此问题,请放心下载。
2. 本文档由用户上传,版权归属用户,汇文网负责整理代发布。如果您对本文档版权有争议请及时联系客服。
3. 下载前请仔细阅读文档内容,确认文档内容符合您的需求后进行下载,若出现内容与标题不符可向本站投诉处理。
4. 下载文档时可能由于网络波动等原因无法下载或下载错误,付费完成后未能成功下载的用户请联系客服处理。
网站客服:3074922707
TM_D_1776_ _D_1776M_ _20
Designation:D1776/D1776M20Standard Practice forConditioning and Testing Textiles1This standard is issued under the fixed designation D1776/D1776M;the number immediately following the designation indicates theyear of original adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of lastreapproval.A superscript epsilon()indicates an editorial change since the last revision or reapproval.This standard has been approved for use by agencies of the U.S.Department of Defense.1.Scope1.1 This practice covers the conditioning and testing oftextiles when conditioning is specified in a test method.Because prior exposure of textiles to high or low humidity mayaffect moisture pick-up equilibrium,a procedure also is givenfor preconditioning the material when required.1.2 The values stated in either SI units or inch-pound unitsare to be regarded separately as standard.The values stated ineach system are not necessarily exact equivalents;therefore,toensure conformance with the standard,each system shall beused independently of the other,and values from the twosystems shall not be combined.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD618 Practice for Conditioning Plastics for TestingD885 Test Methods for Tire Cords,Tire Cord Fabrics,andIndustrial Filament Yarns Made from ManufacturedOrganic-Base FibersD4920 Terminology Relating to Conditioning,Chemical,and Thermal PropertiesD5867 Test Methods for Measurement of Physical Proper-ties of Raw Cotton by Cotton Classification InstrumentsD7269 Test Methods for Tensile Testing of Aramid YarnsD7744 Test Methods for Tensile Testing of High Perfor-mance Polyethylene TapesE337 Test Method for Measuring Humidity with a Psy-chrometer(the Measurement of Wet-and Dry-Bulb Tem-peratures)2.2 ISO Standard:ISO 139 Textiles StandardAtmosphere for Conditioning andTesting33.Terminology3.1 For terminology related to conditioning see Terminol-ogy D4920.3.2 The following terms are relevant to this standard:acceleratedconditioning,moisturecontent,moistureequilibrium,moisture equilibrium for preconditioning,mois-ture equilibrium for testing,precondition,standard atmospherefor preconditioning textiles,standard atmosphere for testingtextiles,uncertainty of(in)measurement.3.3 For definitions of other textile terms used in thisstandard see Terminology D123.4.Summary of Practice4.1 Samples or specimens requiring preconditioning arebrought to relatively low moisture content in a specifiedatmosphere.Samples or specimens not requiring pre-conditioning are brought to moisture equilibrium(specific tofiber-content)according to the standard atmospheres for testingtextiles as shown in Table 1.4.2 Understanding of tolerance and uncertainty of measure-ment has evolved since the creation of the original version ofthis standard.Due to this new understanding,uncertainty ofmeasurement has been taken into account in determiningacceptable tolerances for the standard atmospheres for testingtextiles as shown in Table 1.1This practice is under the jurisdiction ofASTM Committee D13 on Textiles andis the direct responsibility of Subcommittee D13.51 on Conditioning,Chemical andThermal Properties.Current edition approved Feb.1,2020.Published March 2020.Originallyapproved in 1960.Last previous edition approved in 2016 as D1776/D1776M16.DOI:10.1520/D1776_D1776M-20.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer tot he standards Document summary page onthe ASTM website.3Available from American National Standards Institute,11 W.42nd Street,13thFloor,New York,NY 10036.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.5.Significance and Use5.1 The conditioning prescribed in this practice is designedto obtain reproducible results on textiles and textile products.Results of tests obtained on these materials under uncontrolledatmospheres may not be comparable w

此文档下载收益归作者所有

下载文档
你可能关注的文档
收起
展开