ASTM_D_1407_-_65_1990_scan.pdf

ASTM DI1407 65=0759530 0529270 365 41)Designation:D 1407-65(Reapproved 1990)An American National Standard 1 1)Standard:2553 Standard Practice for Measurement and Calibration of Barge Tanks This practice has been approved by the sponsoring committees and accepted by the cooperating societies in accordance with established procedures.This practice describes procedures for calibrating barge tanks.NOTE-other calibration standards are as follows:API Standard 2550-ASTM Methods D 1220,Measurement and Caiibration of Upright Cylindrical Tanks,API Standard 2551-ASTM Methods D 1410,Measurement and Calibration of Stationary Horizontal Tanks,API Standard:2552-ASTM Methods D 1408,Measurement and Calibration of Spherical and Spheroidal Tanks,API Standard 2554-ASTM Methods D 1409,Measurement and Calibration of Tank Car Tanks,and API Standard:2555-ASTM Methods D 1406,Liquid Calibration of Tanks.Due to the special nature of this practice it is of interest to a limited number of the users of this book.The practice,therefore,This practice will not be published by the Amencan Society for Testing and Materiais but will be published by the American is not included in this book.Petroleum Institute.Separate copies will be available from ASTM.T h i s guide is under the jurisdiction of ASTM Committee D-2 on Petroleum Products and Lubricants and is the direct responsibility of Subcommittee W2.02 on Static Petroleum Measurement.Cumnt edition approved Aug.31,1965.Originally published 1956.Last previous edition D 1407-65(1980).519 NOTICE:This standard has either been superseded and replaced by a new version or discontinued.Contact ASTM International(www.astm.org)for the latest information.