ASTM_D_2336_-_99.pdf

Designation:D 2336 99Standard Guide forSpecifying Factory Applied Wood Coatings1This standard is issued under the fixed designation D 2336;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon(e)indicates an editorial change since the last revision or reapproval.1.Scope1.1 This practice summarizes the test methods that may beused to assist in quality control during application and inspecifying pigmented coatings that shall be used in factoryfinishing of wood products.1.2 This practice is not intended for use by the consumer ofcoated wood products in specifying such coated wood prod-ucts.1.3 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:D 154 Guide for Testing Varnishes2D 523 Test Method for Specular Gloss3D 562 Test Method for Consistency of Paints Using theStormer Viscometer3D 869 Test Method for Evaluating Degree of Settling ofPaint4D 968 Test Methods for Abrasion Resistance of OrganicCoatings by Falling Abrasive3D 1005 Test Methods for Measurement of Dry-Film Thick-ness of Organic Coatings Using Micrometers3D 1186 Test Methods for Nondestructive Measurement ofDry Film Thickness of Nonmagnetic Coatings Applied toa Ferrous Base3D 1200 Test Method for Viscosity by Ford Viscosity Cup3D 1210 Test Method for Fineness of Dispersion of Pigment-Vehicle Systems by Hegman-Type Gage3D 1212 Test Methods for Measurement of Wet Film Thick-ness of Organic Coatings3D 1308 Test Method for Effect of Household Chemicals onClear and Pigmented Organic Finishes4D 1310 Test Method for Flash Point and Fire Point ofLiquids by Tag Open-Cup Apparatus3D 1400 Test Method for Nondestructive Measurement ofDry Film Thickness of Nonconductive CoatingsApplied toa Nonferrous Metal Base3D 1474 Test Methods for Indentation Hardness of OrganicCoatings3D 1475 Test Method for Density of Paint,Varnish,Lacquer,and Related Products3D 1644 Test Methods for Nonvolatile Content of Varnishes3D 1729 Practice for Visual Evaluation of Color Differencesof Opaque Materials3D 2065 Test Method for Determination of Edge Perfor-mance of Composite Wood Products Under SurfactantAccelerated Moisture Stress4D 2134 Test Method for Determining the Hardness ofOrganic Coatings with a Sward-Type Hardness Rocker3D 2196 Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational(Brookfield)Viscom-eter3D 2197 Test Methods for Adhesion of Organic Coatings byScrape Adhesion3D 2244 Test Method for Calculation of Color Differencesfrom Instrumentally Measured Color Coordinates3D 2793 Test Method for Block Resistance of Organic Coat-ings on Wood Panel Substrates4D 2794 Test Method for Resistance of Organic Coatings tothe Effects of Rapid Deformation(Impact)3D 2801 Test Method for Leveling Characteristics of Paintsby Draw-Down Method5D 2805 Test Method for Hiding Power of Paints by Reflec-tometry3D 2830 Test Method for Exterior Durability of Factory-Primed Field Finished Wood Products4D 3023 Practice for Determination of Resistance ofFactory-Applied Coatings on Wood Products to Stains andReagents4D 3259 Practice for Infrared Determination of the Tempera-ture of Applied Coatings on Wood Products During theCuring Cycle4D 3278 Test Methods for Flash Point of Liquids by Seta-Flash Closed-Cup Apparatus3D 3359 Test Methods for Measuring Adhesion by TapeTest3D 3363 Test Methods for Film Hardness by Pencil Test31This practice is under the jurisdiction of ASTM Committee D-1 on Paint andRelated Coatings and is the direct responsibility of Subcomittee D01.52 onFactory-Coated Wood Products.Current edition approved Dec.10,1999.Published February 2000.Originallypublished as D 2336 65 T.Last previous edition D 2336 96.2Annual Book of ASTM Standards,Vol 06.03.3Annual Book of ASTM Standards,Vol 06.01.4Annual Book of ASTM Standards,Vol 06.02.5Discontinued;see 1989 Annual Book of ASTM Standards,Vol 06.01.1Copyright ASTM,100 Barr Harbor Drive,West Conshohocken,PA 19428-2959,United States.D 3934 Test Method for Flash/No Flash Test EquilibriumMethod by a Closed-Cup Apparatus3D 3941 Test Method for Flash Point by the EquilibriumMethod with a Closed-Cup Apparatus3D 3960 Practice for Determining Volatile Organic Content(VOC)of Paints and Related Coatings3D 4060 Test Method for Abrasion Resistance of OrganicCoatings by the Taber Abraser3D 4206 Test Methods for Sustained Burning of LiquidMixtures Using the Small Scale Open-Cup Apparatus3D 4212 Test Method for Viscosity by Dip-Type ViscosityCups3D 4287 Test Method for High-Shear Viscosity Using the ICICone/Plate Viscometer3D 4366 Test Methods for Hardness of Organic Coatings byPendulum Damping Tests3D