ASTM_D_4119_-_14.pdf

Designation:D411914Standard Performance Specification forMens and Boys Knitted Dress Shirt Fabrics1This standard is issued under the fixed designation D4119;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This performance specification covers knitted fabricscomprised of any textile fiber or mixture of fibers,used inmens and boys dress shirts.1.2 This performance specification is not applicable toknitted fabrics used for interlinings.1.3 These requirements apply to both the length and widthdirections for those properties where fabric direction is perti-nent.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2.Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD2594 Test Method for Stretch Properties of Knitted FabricsHaving Low PowerD2724 Test Methods for Bonded,Fused,and LaminatedApparel FabricsD3786 Test Method for Bursting Strength of TextileFabricsDiaphragm Bursting Strength Tester MethodD3787 Test Method for Bursting Strength of TextilesConstant-Rate-of-Traverse(CRT)Ball Burst TestD7022 Terminology Relating to Apparel2.2 AATCC Methods:38 Colorfastness to Crocking:Crockmeter Method15 Colorfastness to Perspiration16.3 Colorfastness to Light:Xenon-Arc23 Colorfastness to Burnt Gas Fumes61 Colorfastness to Laundering:Accelerated96Dimensional Changes in Laundering of Woven andKnitted Textiles Except Wool116 Colorfastness to Crocking:Rotary Vertical CrockmeterMethod124 Smoothness Appearance of Fabrics after RepeatedHome Launderings132 Colorfastness to Drycleaning135 Dimensional Changes of Fabrics after Home Launder-ing172 Colorfastness to Powdered Non-chlorine Bleach inHome Laundering188 Colorfastness to Sodium Hypochlorite Bleach in HomeLaunderingEvaluation Procedure No.1 Gray Scale For Color ChangeEvaluation Procedure No.2 Gray Scale for StainingEvaluation Procedure No.8 AATCC 9-Step ChromaticTransference ScaleA Glossary of AATCC Standard Terminology2.3 Federal Standard:416 CFR,Chapter IIConsumer Product Safety CommissionSubchapter DFlammable Fabrics Act Regulations2.4 Military Standard:5MIL-STD-105D Sampling Procedures and Tables for In-spection by AttributesNOTE1Reference to test methods in this performance specificationgive only the permanent part of the designation of ASTM,AATCC,orother test methods.The current editions of each test method cited shallprevail.3.Terminology3.1 For all terminology related to Apparel,see TerminologyD7022.3.1.1 The following term is relevant to this standard:dimen-sional change.3.2 For definitions of all other textile terms see TerminologyD123.1This performance specification is under the jurisdiction of ASTM CommitteeD13 on Textiles and is the direct responsibility of Subcommittee D13.61 onApparel.Current edition approved Feb.1,2014.Published March 2014.Originallyapproved in 1982.Last previous edition approved in 2008 as D4119 01(2008).DOI:10.1520/D4119-14.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3AATCC Technical Manual,available from American Association of TextileChemists and Colorists(AATCC),P.O.Box 12215,Research Triangle Park,NC27709,http:/www.aatcc.org.4Available from Superintendent of Documents,Government Printing Office,Washington,DC 20402.5Available from Standardization Documents Order Desk,Bldg.4 Section D,700Robbins Ave.,Philadelphia,PA 19111-5094,Attn:NPODS.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 3.3 For terms relating to chemical or colorfastness testing,refer to specific AATCC test method,or the Glossary ofAATCC Standard Terminology.3.4 Definitions of terms found in a dictionary of commonterms are suitable for this performance specification.3.5 Definitions of Terms Specific to This Standard:3.5.1 pressing and finishingthis term takes into account allof the industrial pressing and finishing treatments used ingarment production.NOTE2No method is available for reproducing on a laboratory levelthe results of industrial press or finishing treatments,or both,used in themanufacture of garments.4.Specification Requirements4.1 The properties of fabrics for mens and boys knitteddress shirts shall conform to the specification requirements inTable 1.5.Significance and Use5.1 Upon agreement between the purchaser and the seller,fabrics intended for this end use should meet all of therequirements listed in Table 1 o