ASTM_D_4115_-_20.pdf

Designation:D411520Standard Performance Specification forWomens and Girls Knitted and Woven Dress GloveFabrics1This standard is issued under the fixed designation D4115;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This performance specification covers woven and knit-ted fabrics comprised of any textile fiber or mixture of fibers tobe used in womens and girls dress gloves.1.2 This performance specification is not applicable tofabrics used for interlinings and industrial-protective clothing.1.3 These requirements apply to the length and widthdirections for those properties where each fabric direction ispertinent.1.4 The following precautionary statement pertains only tothe test methods portion,Section 7,of this performancespecification.This standard does not purport to address all ofthe safety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety,health,and environmental practices and deter-mine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Referenced Documents2.1 ASTM Standards:2D123 Terminology Relating to TextilesD434 Test Method for Resistance to Slippage of Yarns inWoven Fabrics Using a Standard Seam(Withdrawn2003)3D1424 Test Method for Tearing Strength of Fabrics byFalling-Pendulum(Elmendorf-Type)ApparatusD2261 Test Method for Tearing Strength of Fabrics by theTongue(Single Rip)Procedure(Constant-Rate-of-Extension Tensile Testing Machine)D2262 Test Method for Tearing Strength of Woven Fabricsby the Tongue(Single Rip)Method(Constant-Rate-of-Traverse Tensile Testing Machine)(Withdrawn 1995)3D2724 Test Method for Bond Strength of Bonded,Fused,and Laminated Apparel FabricsD3786 Test Method for Bursting Strength of TextileFabricsDiaphragm Bursting Strength Tester MethodD3787 Test Method for Bursting Strength of TextilesConstant-Rate-of-Traverse(CRT)Ball Burst TestD5034 Test Method for Breaking Strength and Elongation ofTextile Fabrics(Grab Test)D7022 Terminology Relating to Apparel2.2 AATCC Test Methods:4TM8 Colorfastness to Crocking:Crockmeter MethodTM16.3 Colorfastness to Light:Xenon-ArcTM23 Colorfastness to Burnt Gas FumesTM61 Colorfastness to Laundering,Commercial:Acceler-atedTM116 Colorfastness to Crocking:Rotary Vertical Crock-meter MethodTM132 Colorfastness to DrycleaningTM135 Dimensional Changes of Fabrics after Home Laun-deringTM172 Colorfastness to Powdered Non-chlorine Bleach inHome LaunderingTM188 Colorfastness to Sodium Hypochlorite Bleach inHome LaunderingEP1 Gray Scale for Color Change1This performance specification is under the jurisdiction of ASTM CommitteeD13 on Textiles and is the direct responsibility of Subcommittee D13.61 onApparel.Current edition approved Feb.1,2020.Published February 2020.Originallyapproved in 1982.Last previous edition approved in 2014 as D4115 14.DOI:10.1520/D4115-20.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.4Available from American Association of Textile Chemists and Colorists(AATCC),P.O.Box 12215,Research Triangle Park,NC 27709,http:/www.aatcc.org.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 Copyright by ASTM Intl(all rights reserved);Tue Feb 25 21:39:59 EST 2020Downloaded/printed byPurdue University Libraries(Purdue University Libraries)pursuant to License Agreement.No further reproductions authorized.EP2 Gray Scale for StainingEP8 AATCC 9-Step Chromatic Transference Scale.M11 A Glossary of AATCC Standard Terminology2.3 Federal Standard:516 CFR 1610 Standard for Flammability of Clothing Tex-tiles16 CFR,Chapter IIConsumer Product Safety CommissionSubchapter DFlammable Fabrics Act Regulations2.4 Military Standard:6MIL-STD-105D Sampling Procedures and Tables for In-spection by AttributesNOTE1Reference to test methods in this standard give only thepermanent part of the desi