温馨提示:
1. 部分包含数学公式或PPT动画的文件,查看预览时可能会显示错乱或异常,文件下载后无此问题,请放心下载。
2. 本文档由用户上传,版权归属用户,汇文网负责整理代发布。如果您对本文档版权有争议请及时联系客服。
3. 下载前请仔细阅读文档内容,确认文档内容符合您的需求后进行下载,若出现内容与标题不符可向本站投诉处理。
4. 下载文档时可能由于网络波动等原因无法下载或下载错误,付费完成后未能成功下载的用户请联系客服处理。
网站客服:3074922707
TM_D_4009_
_92_2017
Designation:D400992(Reapproved 2017)Standard Guide forFoam Stability of Hand Dishwashing Detergents1This standard is issued under the fixed designation D4009;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This guide provides guidelines for several techniques ofmeasuring the foam stability of light-duty hand dishwashingdetergent products in the presence of artificially applied test-food soils.It is intended as a laboratory screening test to aid inthe formulation of products,for quality control and as a basisbetween the formulator and supplier in standardizing foamstability of the detergents.1.2 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.This standard doesnot purport to address all of the safety concerns,if any,associated with its use.It is the responsibility of the user of thisstandard to establish appropriate safety,health,and environ-mental practices and determine the applicability of regulatorylimitations prior to use.1.3 This international standard was developed in accor-dance with internationally recognized principles on standard-ization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recom-mendations issued by the World Trade Organization TechnicalBarriers to Trade(TBT)Committee.2.Summary of Guide2.1 Soiled dinner plates are washed by hand in solutions ofhand dishwashing detergents under standardized conditionsuntil an end point of near-disappearance of the foam is reached,after which the number of plates washed is compared to thenumber of plates washed using a standard product.3.Significance and Use3.1 The guide,as now constituted,is not suitable for rankingof hand dishwashing products,since no basis is available at thistime for correlation of the foam stability of these productsusing any particular food soil or combination of soils withconsumers ranking of performance.3.2 The relative foam stability ranking of hand dishwashingdetergent products will vary greatly depending on the type offood soils used in the test.Therefore,selection of the standardfood soil to be used in a test shall be made by agreementbetween the interested parties on the basis of experience.3.3 This laboratory screening guide includes flexibility inseveral areas so as to allow its use by the maximum number oflaboratories,without purchase of significant additional equip-ment.It should be recognized,therefore,that differences inspecific equipment may result in a reduced level of interlabo-ratory and inter-operator precision,and such results must beevaluated with caution.4.Recommended Conditions4.1 Water HardnessIf only one test is to be made,hardwater(150 ppm,about 9 grains per gallon(gpg)is suggested.To produce a more complete picture of product foam stability,test at two or three additional hardness levels:soft water(35ppm,2 gpg);moderately hard water(100 ppm,6 gpg);or veryhard water(260 ppm,15 gpg).4.1.1 Calcium/Magnesium Ratio(as CaCo3)It is sug-gested that this ratio be adjusted for different water hardness asfollows:Water Hardness Range,ppm(gpg)Calcium/MagnesiumRatio0 to 60(0 to 3.5)4:161 to 120(3.6 to 7.0)3:1121 and over(7.1 and over)2:14.2 Water TemperatureThe water temperature at the startof the test should be adjusted to 47C(117F).5.Materials5.1 Plain White Glazed Dinner Plates in Sound Condition200 to 230 mm(8 to 9 in.)in diameter,with 160 to 165 mm(614to 612in.)indented bottom.5.2 Dishpan(conventional)Bottom diameter=280 mm(11 in.),top diameter=370 mm(1412in.),depth=140 mm(512in.).Sheet metal or plastic are suitable materials.5.3 Dishcloth(any conventional brand),Dish Mop,orDisposable DishclothsEnough clean dish cloths(or dishmops)should be available to ensure the use of a fresh cloth(or1This guide is under the jurisdiction of ASTM Committee D12 on Soaps andOther Detergents and is the direct responsibility of Subcommittee D12.16 on HardSurface Cleaning.Current edition approved Nov.1,2017.Published November 2017.Originallyapproved in 1981.Last previous edition approved in 2011 as D4009 92(2011).DOI:10.1520/D4009-92R17.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United StatesThis international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for theDevelopment of International Standards,Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade(TBT)Committee.1 dish mop)for each test run in one day.A new disposable c