ASTM_D_6622_-_01_2009.pdf

Designation:D662201(Reapproved 2009)Standard Guide forApplication of Fully Adhered Hot-Applied ReinforcedWaterproofing Systems1This standard is issued under the fixed designation D6622;the number immediately following the designation indicates the year oforiginal adoption or,in the case of revision,the year of last revision.A number in parentheses indicates the year of last reapproval.Asuperscript epsilon()indicates an editorial change since the last revision or reapproval.1.Scope1.1 This guide covers the minimum installation recommen-dations for fully adhered,hot-applied reinforced waterproofingsystems on vertical and low-slope(plaza deck)surfaces.1.2 For the purpose of this guide,the substrate is assumed tobe concrete or masonry,structurally sound,able to accept theweight of anticipated loads,and meets the local building coderequirements.Similarly,all components of the waterproofingsystem are assumed to comply with any federal,state,and localenvironmental regulations that may be in effect at the time ofinstallation.Expansion joints,insulation,drainage layers,andoverburden are beyond the scope of this guide.1.3 The values stated in SI units are to be regarded as thestandard.The values given in parentheses are for informationonly.1.4 This standard does not purport to address all of thesafety concerns,if any,associated with its use.It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory requirements prior to use.2.Referenced Documents2.1 ASTM Standards:2C981 Guide for Design of Built-Up Bituminous MembraneWaterproofing Systems for Building DecksD41 Specification for Asphalt Primer Used in Roofing,Dampproofing,and WaterproofingD43 Specification for Coal Tar Primer Used in Roofing,Dampproofing,and WaterproofingD173 Specification for Bitumen-Saturated Cotton FabricsUsed in Roofing and WaterproofingD226 Specification for Asphalt-Saturated Organic Felt Usedin Roofing and WaterproofingD227 Specification for Coal-Tar-Saturated Organic FeltUsed in Roofing and WaterproofingD449 Specification for Asphalt Used in Dampproofing andWaterproofingD450 Specification for Coal-Tar Pitch Used in Roofing,Dampproofing,and WaterproofingD1079 Terminology Relating to Roofing and WaterproofingD1327 Specification for Bitumen-Saturated Woven BurlapFabrics Used in Roofing and WaterproofingD1668 Specification for Glass Fabrics(Woven and Treated)for Roofing and WaterproofingD2178 Specification for Asphalt Glass Felt Used in Roofingand WaterproofingD2822 Specification for Asphalt Roof Cement,Asbestos-ContainingD4022 Specification for Coal Tar Roof Cement,AsbestosContainingD4586 Specification for Asphalt Roof Cement,Asbestos-FreeD4990 Specification for Coal Tar Glass Felt Used in Roofingand WaterproofingD5295 Guide for Preparation of Concrete Surfaces for Ad-hered(Bonded)Membrane Waterproofing SystemsD5643 Specification for Coal Tar Roof Cement,AsbestosFreeD5726 Specification for Thermoplastic Fabrics Used in Hot-Applied Roofing and WaterproofingD5898 Guide for Details for Adhered Sheet WaterproofingD5957 Guide for Flood Testing Horizontal WaterproofingInstallationsD6152 Specification for SEBS-Modified Mopping AsphaltUsed in RoofingD6162 Specification for Styrene Butadiene Styrene(SBS)Modified Bituminous Sheet Materials Using a Combina-tion of Polyester and Glass Fiber Reinforcements1This guide is under the jurisdiction of ASTM Committee D08 on Roofing andWaterproofing and is the direct responsibility of Subcommittee D08.22 on Water-proofing and Dampproofing Systems.Current edition approved Jan.1,2009.Published January 2009.Originallyapproved in 2001.Last previous edition approved in 2001 as D6622 01.DOI:10.1520/D6622-01R09.2For referenced ASTM standards,visit the ASTM website,www.astm.org,orcontact ASTM Customer Service at serviceastm.org.For Annual Book of ASTMStandards volume information,refer to the standards Document Summary page onthe ASTM website.Copyright ASTM International,100 Barr Harbor Drive,PO Box C700,West Conshohocken,PA 19428-2959.United States1 D6163 Specification for Styrene Butadiene Styrene(SBS)Modified Bituminous Sheet Materials Using Glass FiberReinforcementsD6164 Specification for Styrene Butadiene Styrene(SBS)Modified Bituminous Sheet Materials Using PolyesterReinforcementsD6451 Guide for Application of Asphalt Based ProtectionBoardD6506 Specification for Asphalt Based Protection Board forBelow-Grade Waterproofing2.2 Other Documents:CAN/CGSB-37.50 Hot-Applied,Rubberized Asphalt forRoofing and Waterproofing3CAN/CGSB-37.51 Application for Hot-Applied RubberizedAsphalt for Roofing and Waterproofing33.Terminology3.1 DefinitionsFor definitions of terms used in this guide,refer to Terminology D1079.4.Classification4.1 The following types are used to identify the waterproof-ing systems included in this guide.4.1.1 Type IMembranes consisting of hot-applied coal tarpitch,and two or more layers of organic or inorganic felts orfabr