SPPE_2B-1995.pdf

ASME SPPE-2B95075967005b4b18205AN AMERICAN NATIONAL STANDARDASME SPPE-2b-1995ADDENDAtoASME SPPE-2-1994ACCREDITATION OF TESTING LABORATORIESFOR SAFETY AND POLLUTIONPREVENTION EQUIPMENT USED INOFFSHORE OIL AND GAS OPERATIONSTHE AMERICAN SOCIETY OF MECHANICAL ENGINEERSUnited Engineering Center345East47 th StreetNew York,N.Y.10017ASME SPPE-2B 95 0759670 0564620 963ASME SPPE-2b-1995Following approval by the Main Committee of SPPE and the Sponsor,and after public review,thisASME SPPE-2b-1995 was approved by the American National Standards Institute on June 12,1995.Addenda to the 1994 edition of ASME SPPE-2 are issued in the form of replacement pages.Revisions,additions,and deletions are incorporated directly into the affected pages.It is advisablehowever,that this page,the Addenda title and copyright pages,and all replaced pages be retainedfor reference.SUMMARY OF CHANGESThis is the second Addenda to be published to ASME SPPE-2-1994.The first Addenda was pub-lished on October 31,1994.Replace or insert the pages listed.Changes given below are identified on the pages by a marginnote,(b),placed next to the affected area.Changes made in SPPE-2-1994 and in the first Addendaare identified on the pages by margin notes 94 and(a),respectively.PageLocationChangeivStatements of PolicyRevised in their entirety11LA-5200Revised13Appendix IListing for API Specification 14D revised(c)ASME SPPE-2B9507596700564b218TTFOREWORD94(This Foreword is not part of ASME SPPE-2-1994.)This Standard was developed under procedures accredited as meeting the criteria forAmerican National Standards.The consensus committee that approved the Standard wasbalanced to assure that individuals from competent and concerned interests have had anopportunity to participate.Safety codes and standards are intended to enhance public health and safety.Revisionsresult from committee consideration of factors such as technological advances,new dataand changing environmental and industry needs.Revisions do not imply that previouseditions were inadequate.The paragraph numbers in SPPE-2 may contain intentionally inserted gaps in consec-utive numbering.This Standard is available for public review on a continuing basis.This provides anopportunity for additional public input from industry,academia,regulatory agencies,andthe public-at-large.The use of an addenda system will allow revisions made in responseto public review comments or committee actions to be published on a regular 6 monthbasis.For ASME Accreditation,revisions published by addenda become mandatory 6months after the date of issuance but may be used voluntarily from the date of issuance.Following approval by the Main Committee of SPPE and the ASME,and after publicreview,ASME SPPE-2-1994 was approved by the American National Standards Instituteon April 5,1994.的