ASME_B94.19-1997.pdf

及品r3。otAN AMERICANN ATIO N ALSTANDARDMILLING CUTTERSAND END MILLSREAFFIRMED 2014FOR CURRENT COMMITTEE PERSONNELPLEASE E-MAIL CSASME.ORGASMEB94.19-1997(Revision ol ANSI/ASME B94.19-1985Date of Issuance:March 20,1998This Standard will be revised when the Society approves the issuance ofa new edition.There will be no addenda or written interpretations of therequirements of this Standard issued to this Edition.ASME is the registered trademark of The American Society of Mechanical Engineers.This code or standard was developed under procedures accredited as meeting the criteria forAmerican National Standards.The Consensus Committee that approved the code or standardwas balanced to assure that individuals from competent and concerned interests have had anopportunity to participate.The proposed code or standard was made available for public reviewand comment which provides an opportunity for additional public input from industry,academiaregulatory agencies,and the public-at-large.ASME does notapprove,rate,or endorseany item,construction,proprietary device,or activity.ASME does not take any position with respect to the validity of any patent rights asserted inconnection with any items mentioned in this document,and does not undertake to insure anyoneutilizing a standard against liability for infringement of any applicable Letters Patent,nor assumeany such liability.Users of a code or standard are expressly advised that the determination ofthe validity of any such patent rights,and the risk of the infringement of such rights,is entirelytheir own responsibility.Participation by federal agency representative(s)or person(s)affiliated with industry is not to,be interpreted as government or industry endorsement of this code or standard.ASME accepts responsibility for only those interpretations issued in accordance with goveringASME procedures and policies which preclude the issuance of interpretations by individualvolunteers.No part of this document may be reproduced in any form.in an electronic retrieval system or otherwise,without the prior written permission of the publisher.The American Society of Mechanical Engineers345 East 47th Street,New York,NY 10017Copyright1998byTHE AMERICAN SOCIETY OF MECHANICAL ENGINEERSAll Rights ReservedPrinted in U.S.A.