ASME_B5.60A-2005.pdf

ASME B5.60a-2005Following approval by the ASME B5 Committee and ASME,and after public review,ASME B5.60a-2005was approved by the American National Standards Institute on February 24,2005.Addenda to the 2002 edition of ASME B5.60 are issued in the form of replacement pages.Revisions,additions,and deletions are incorporated directly into the affected pages.It is advisable,however,that thispage,the Addenda title and copyright pages,and all replaced pages be retained for reference.SUMMARY OF CHANGESThis is the first Addenda to be published to ASME B5.60-2002Replace or insert the pages.Changes given below are identified on the pages by a margin note,(a).placednext to the affected area.The pages not listed are the reverse sides of the listed pages and contain nochanges.PageLocationChange进ContentsUpdated to reflect AddendaivForewordUpdated to reflect AddendaCommittee RosterUpdated to reflect AddendaviiPrefaceUpdated to reflect Addenda11-21ASME B5.60.5Added(c)No roproduction or notworking permitled without liconso from IHSNot for RosaleCONTENTS(a)Foreword.ivStandards Committee Roster.Correspondence With the B5 Committee父preface.iASME B5.60.1 General Description and Definitions of Terms.1ASME B5.60.2 Chuck-to-Spindle Interface(to be added)ASME B5.60.3 Jaw Mountings(to be added).ASME B5.60.4 Performance Testing.5ASME B5.60.5 Safety Code of Practice.11ASME B5.60.6 Chuck Assembly:Sizes and Designation(to be added).讲No roproduction or notworking permitled without liconso from IHSNot for Rosale