ASME_B5.60-2002.pdf

ASMEB5.60-2002WORKROLDINGCHUCKS:JAWTYPE CHUCKSIncorporating ASME B5.60.1 and ASME B5.60.4AN AMERICAN NATIONAL STANDARDThe American Society ofMechanical Engineerst oenee trowhAThe American Society ofMechanical EngineersA N AM E R I C AN N AT I ON A L STAN D A R DWORKHOLDINGCHUCKS:JAWTYPE CHUCKSIncorporating ASME B5.60.1 and ASME B5.60.4ASMB5.60-2002No roproduction or notworking permimod without lcense from IHSNot for ResaleFOREWORDDuring the review,revision,and update of the existing inch-based American NationalStandard B5.8 on Chucks and Chuck Jaws,Technical Committee 11 of the ASME B5Committee on Machine Tools recognized the need for an industry standard on metric-dimensioned chucks.This Standard was developed after reviewing currently available national and internationalstandards,which were used as its foundation.B50.60.1 and B5.60.4 were completed in November 1999 and submitted to ASME.The standard titled,Workholding Chucks:Jaw Type Chucks,comprises six parts,witheach covering a specific aspect of workholding chucks,as follows:ASME B5.60.1:General Description and Definitions of TermsASME B5.60.2:Chuck-to-Spindle InterfaceASME B5.60.3:Jaw MountingsASME B5.60.4:Performance TestingASME B5.60.5:Safety Code of PracticeASME B5.60.6:Chuck Assembly:Sizes and DesignationASME B5.60.1 was approved by the American National Standards Institute on June 26,2002ASME B5.60.4 was approved by the American National Standards Institute on June 26,2002.ASME B5.60.2,ASME B5.60.3,ASME B5.60.5,and ASME B5.60.6 will be added.ivCapynaASlngnatondwith ASMEmmed without licerse from IHSNot for Resale