ASME_B107.35M-1997.pdf

STD.ASME B107.35M-EN6L199707596700583055bT6mASME B107 35M-1997NUT DRIVERSSPIN TYRESCREDRIVER CRIPMEPHG SERIE图AN AMERICAN NATIONAL STANDARDThe American Society ofMechanical EngineersCOPYRICHT Ameriean Society of Mechandeal EngineersLicensed by Information Handling ServicesSTD.ASME B107.35M-EN6L199707596700583056532The American Society ofMechanical EngineersAMERIC AN NATION A LSTAN D A RDNUT DRMERSSPIN TYPE.SCREWORIVER GRIPMETRIC SERIESASME B107.35M-1997COPYRIGHT American Society of Mechanical EngineersLicensed by Information Handling ServicesSTD.ASME B107.35M-EN6L19970759b7005B3058305FOREWORD(This Foreword is not part of ASME B107.35M-1997.)The American National Standards Committee B107,Hand Tools and Accessories,undersponsorship by The American Society of Mechanical Engineers,held its organizationalmeeting on June 28,1967.Subcommittees were subsequently organized to handle theexpanded need of both inch and metric series American National Standards dealing withvarious hand tools.This Standard is one of a series of such standards.Members of the Hand Tools Institute have been major contributors to the developmentof these standards in their committee work,their knowledge of the products,and theiractive efforts in promoting the adoption of the standards.When the Hand Tools Institute Standards Committee considered revising the original NutDriver Standard,ASME B107.12,it was decided that a better standard could be written ifthe metric nut drivers was separated from the inch seris.This edition of the Standard was submitted to industry for review and comment.Followingapproval by ASME Standards Committee B107,it was approved by the American NationalStandards Institute on February 6,1997.讲COPYRIGHT American Society of Mechanical EngineersLicensed by Information Handling ServicesSTD.ASME B107.35M-EN6L19970759b700583059241ASME STANDARDS COMMITTEE B107Hand Tools and Accessories(The following is the roster of the Committee at the time of approval of this Standard.)OFFICERSR.R.MeCullough,ChairR.B.Wright,Vice ChairG.L.Fechter,SecretaryCOMMITTEE PERSONNELR.M.Byrne,Trade Association Management,IncA.A.Speranza,Alternate,Hand Tools InstituteG.L.Fechter,The American Society of Mechanical EngineersR.P.Hall,U.S.Air ForceA.Herskovitz,U.S.Department of the ArmyS.Jiles,Southern California GasC.M.Knapp.U.S.Air ForceJ.C.Marvil,General Services AdministrationA.Carr,Alternate,General Services AdministrationR.R.McCullough,Cooper IndustriesG.E.Olson,ConsultantB.Pagac,Snap-On,Inc.R.W.Reynolds,Stanley Mechanics ToolsW.R.Wacker,BAC Associates.Inc.R.B.Wright,Wright Tool Co.COPYRIGHT American Society of Mechanical EngineersLicensed by Information Handling Services