ASME_A112.19.14-2001.pdf

Supplement 1-2003toASME A112.19.14-2001Six-Liter Water Closets Equipped With a Dual Flushing Device(This Supplement was approved as an American National Standard on June 20,2003.)Paragraph 3.2.4.2 has been reviscd.The revised paragraphappears below.3.2.4.2 Performance Requirement.A dilutionratio of at least 17:1 shall be obtained in each initialflush,for the average of the three tests.The procedureshall be repeated until three sets of data are obtained.Copyright 2003THE AMERICAN SOCIETY OF MECHANICAL ENGINEERSThree Park Avenue,New York,NY 10016-5990All Rights ResorvedJ0165ACopyright by the American Society Of Mechanical EngineersThe American Society ofMechanicai EngineersA N AMERICAN N ATI O N AL STAN D A R DSIX-LITER WATCLOSETS EOUIPP田LUSHING DEVICE4tA112.19.14-2001Date of Issuance:August 1,2002This Standard will be revised when the Society approves the issuance of anew edition.There will be no addenda to this edition.ASME issues written replies to inquires concerning interpretations oftechnical aspects of this Standard.4ASME is the registered trademark of The American Society of Mechanical Engineers.This code or standard was developed under procedures accredited as meeting the criteria forAmerican Nationa!Standards.The Standards Committee that approved the code or standard4was balanced to assure that individuals from competent and concerned interests have had anopportunity to participate.The proposed code or standard was made available for public reviewand comment that provides an opportunity for additional public input from industry,academia,regulatory agencies,and the public-at-large.ASME does not approve.rate.or endorseany item,construction,proprietary device.or activity.ASME does not take any position with respect to the validity of any patent rights asserted inconnection with any items mentioned in this document,and does not undertake to insure anyoneutilizing a standard against liability for infringement of any applicable letters patent,nor assumesony such liability.Users of a code or standard are expressly advised that determination of thevalidity of any such patent rights,and the risk of infringement of such rights,is entirely theirown responsibility.Participation by federal agency representative(s)or person(s)affilialed with industry is not tobe interpreted as government or industry endorsement of this code or ctandard.ASME accepts responsibility for only those interpretations of this document issued inaccordance with the established ASME procedures and policies,which preciudes the issuanceof interpretations by individuals.No part of this document may be reproduced in any form,in an electronic retrieval system or otherwise,without the prior written permission of the publisherThe American Society of Mechanical EngineersThree Park Avenue,New York,NY 10016-5990Copyright2002byTHE AMERICAN SOCIETY OF MECHANICAL ENGINEERSAll Righis ReservedPrinted in U.S.A.