_API_St_613-2003_2007.pdf

Special Purpose Gear Units forPetroleum,Chemical and GasIndustry ServicesANSI/API STANDARD 613FIFTH EDITION.FEBRUARY 2003ERRATA,DECEMBER 5,2005REAFFIRMED,AUGUST 2007ener光1(ANSIAMERICAN PETROLEUM INSTITUTENo roproduction or notworking permitled without liconso from IHSSpecial Purpose Gear Units forPetroleum,Chemical and GasIndustry ServicesDownstream SegmentANSI/API STANDARD 613FIFTH EDITION,FEBRUARY 2003ERRATA,DECEMBER 5,2005REAFFIRMED,AUGUST 2007enerAPI(ANSIAMERICAN PETROLEUM INSTITUTENo roproduction or notworking permitled without liconso from IHSSPECIAL NOTESAPI publications necessarily address problems of a general nature.With respect to partic-ular circumstances,local,state,and federal laws and regulations should be reviewed.API is not undertaking to meet the duties of employers,manufacturers,or suppliers towarn and properly train and equip their employees,and others exposed,concerning healthand safety risks and precautions,nor undertaking their obligations under local,state,or fed-eral laws.Information concerning safety and health risks and proper precautions,with respect toparticular materials and conditions,should be obtained from the employer,the manufactureror supplier of that material,or the material safety data sheet.Nothing contained in any API publication is to be construed as granting any right,byimplication or otherwise,for the manufacture,sale,or use of any method,apparatus,or prod-uct covered by letters patent.Neither should anything contained in the publication be con-strued as insuring anyone against liability for infringement of letters patent.Generally,API standards are reviewed and revised,reaffirmed,or withdrawn at least everyfive years.Sometimes a one-time extension of up to two years will be added to this reviewcycle.This publication will no longer be in effect five years after its publication date as anoperative API standard or,where an extension has been granted,upon republication.Statusof the publication can be ascertained from the API Downstream Segment telephone(202)682-80001.A catalog of API publications and materials is published annually and updatedquarterly by API,1220 L Street,N.W.,Washington,D.C.20005,www.api.org.This document was produced under API standardization procedures that ensure appropri-ate notification and participation in the developmental process and is designated as an APlstandard.Questions concerning the interpretation of the content of this standard or com-ments and questions concerning the procedures under which this standard was developedshould be directed in writing to the Director,Standards Department,American PetroleumInstitute,1220 L Street,N.W.,Washington,D.C.20005,standardsapi.org.Requests forpermission to reproduce or translate all or any part of the material published herein shouldalso be addressed to the general manager.API standards are published to facilitate the broad availability of proven,sound engineer-ing and operating practices.These standards are not intended to obviate the need for apply-ing sound engineering judgment regarding when and where these standards should beutilized.The formulation and publication of API standards is not intended in any way toinhibit anyone from using any other practices.Any manufacturer marking equipment or materials in conformance with the markingrequirements of an API standard is solely responsible for complying with all the applicablerequirements of that standard.API does not represent,warrant,or guarantee that such prod-ucts do in fact conform to the applicable API standard.All rights reserved.No part of this work may be reproduced,stored in a retrieval system,ortransmitted by any means,electronic,mechanical,photocopying,recording,or otherwise,without prior written permission from the publisher Contact the Publisher.API Publishing Services,1220 L Street,N.W.,Washington,D.C.20005.Copyright 2003 American Petroleum InstituteNo roproduction or notworking permitled without liconso from IHS